Datapath VSN450 Manuel d'utilisateur télécharger pdf (Page 9)

Onboard Graphics Adaptor Disabled

If you do not require a control screen, then you should disable the integrated graphics as described below.

Connect a monitor to the onboard graphics device output and enter setup from the boot screen by

pressing <DEL> as prompted.

In the BIOS setup utility select:

Advanced Mode>System Agent Conguration>Graphics Conguration>

Primary Display [PCIE]

If the onboard graphics is disabled, a PCIe graphics device should be installed in slot 1 on the

motherboard, slot 1 is located nearest to the CPU.

Use of the Onboard Graphics Adaptor

Onboard Graphics Adaptor used as Control Screen

The VSN450 is shipped with the BIOS congured to boot o the onboard graphics device. This output can

then be used as the control screen for a typical wall conguration.

To set the system to boot on the onboard graphics device (“Internal Graphics Processing Unit” - IGPU),

enter setup from the boot screen by pressing <DEL> as prompted.

In the BIOS setup utility select:

Advanced Mode>System Agent Conguration>Graphics Conguration>

Primary Display [IGPU]

Fig.6

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Datapath VSN450 Manuel d'utilisateur Page 9