Datapath VSN890 Manuel d'utilisateur télécharger pdf (Page 8)

Software

Each VSN890 shipped by Datapath is custom built. If cards are not pre-installed then installation of the

software is required. For information on software installation consult the relevant user manual contained

on the installation CD.

If you have ordered Datapath Wall Control-red software and this has been installed prior to shipment,

please ensure the Wall Control-red hardware USB key is installed before system boot up.

To install the Wall Control-red hardware USB key, remove from its packaging and insert it into a vacant

USB port as shown below:

Fig.4

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Datapath VSN890 Manuel d'utilisateur Page 8